Surface Preparation

• For proper adhesion of the product, the surface to be painted must be cleaned of dust, grease, oils, peeled old paints, rust, mold residues, or moisture.
• For new or porous surfaces, first apply the corresponding recommended primer of the product (Life dur, Life dur water).
• Apply the product with the special RELIEF roller in 2 coats (after thoroughly mixing it) with a 1 - 2 hour interval between them. The product reaches all its mechanical strengths after 20 - 30 days.

Characteristics:

• Coverage: 1-1.5m² / Kg per coat
• Thinning: First coat: 5% water. Second coat: no thinning
• Drying: 1 - 2 hours depending on application conditions

Application Conditions:

• Avoid applying the product at temperatures below 6°C and above 40°C as well as when relative humidity is higher than 80%. Adverse conditions during application can alter the final properties of the paint.

Application Tools:

• Brush
• Roller

During work, keep the tools “wet” inside the container or the product’s vessel. Drain the tools well back into the can and clean them immediately with warm water and soap. If the product dries, it can only be removed with strong detergents. Do not dispose of wash water into the groundwater.

Warning: Wear protective gloves, protective clothing, and personal protective equipment for eyes and face. In case of contact with eyes, rinse carefully with plenty of water for several minutes. If contact lenses are worn and easy to remove, take them out. Continue rinsing.