3D Printer Controller For RAMPS 1.4 Reprap Mendel Prusa Support Arduino Board

Fully assembled & tested, no soldering required.

Designed to fit all the electronics required for a RepRap in a small package with low cost.

The modular design includes plugs for stepper motors and extruder control electronics in a protective Arduino MEGA shield for easy servicing, part replacement, upgrade, and expansion.

Capability to add multiple Arduino expansions to the system, provided the main RAMPS board is kept on top of the stack.

Size: Approximately 11.5 x 6 cm / 4.53 x 2.36 inch

Package includes:

• 1 x 3D printer controller for RAMPS 1.4