Thanks to Inverter technology, it maintains a stable temperature and lower consumption compared to standard instant water heaters as it uses only the necessary power to heat the water to the desired temperature.

It is central and can be used either as the main option for heating the domestic water in your home, or as a supplementary option. It can provide hot water throughout the house for your daily needs, as long as there are suitable pipes for the distribution of hot water. This may potentially result in heat and energy losses due to the distance.

It has two main installation methods, free flow and line (pressure). Additionally, the Solcore instant water heater can be connected in a hybrid series with the solar water heater, with solar collectors, with the central heating boiler, or with the hot water from the gas boiler.

It is equipped with a built-in digital display that shows you the water temperature and also gives you the option to select it yourself.

• Easy and quick installation.
• 6th generation cast aluminum heating element technology (0% Salts).
• Dynamic temperature control “DTC” from 30°C – 60°C.
• LED digit display & touch selectors for settings and customization.
• Power range adjustment (255 SMART POWER).
• Hybrid installation technology.
• Multiple safety valves.
• Continuous self-diagnosis of proper operation and faults.
• Innovative design.

The instant water heater is a type of water heater that heats water in real-time. It only heats the water that passes through it at that moment. There is no hot water storage tank. This has many advantages, such as energy savings, since only the water that is used is heated, and longer lifespan, as there is no water tank and no accumulation of salts on the resistance and other components.

It operates with electricity and is three-phase, meaning a three-phase power supply is required.

The instant water heater has a cold water inlet pipe, which passes through the resistance, heats up, and exits through the hot water outlet pipe. A necessary condition for the instant water heater to initially operate is the pressure of the incoming cold water should not be too low.

The water temperature is regulated by a thermostat, so it does not exceed a maximum value. The temperatures that the hot water reaches are pre-set so that one can use the hot water directly, without needing to mix it with cold water.

The maximum temperature it can reach for hot water production is 60 °C, while the maximum water flow rate reaches up to 10 liters per minute. Indicatively, 38-42 °C degrees are standard for shower use.

• It is small in size and does not take up much space.
• There are no energy losses, as only the water being used at that moment is heated. Therefore, we save on the electricity bill. In a traditional water heater, the hot water that is not used goes to waste.
• The hot water used in the instant water heater is used as is, without mixing with cold, as happens in a traditional water heater. Thus, we also save water, in addition to electricity.
• There is no need to wait for the water to heat up. As soon as we turn on the tap, hot water flows in a few seconds. The traditional water heater takes a few minutes, depending on its size.
• The hot water never runs out. As long as we have the tap open, we will have hot water.