- 100 levels of vibration
- 100 levels of shock electricity
- Transmission frequency: 433 ~ 825MHz
- The transmitter and receiver have a 3.7V/550mAh rechargeable lithium battery
- Waterproof receiver
Electronic dog training collar with a range of up to 300 meters. The device is completely harmless to the pet, as it operates with vibrations and ultrasonic sounds.
Product Features
- 100 levels of vibration
- 100 levels of shock electricity
- Transmission frequency: 433 ~ 825MHz
- The transmitter and receiver have a 3.7V/550mAh rechargeable lithium battery
- Waterproof receiver
Remote Control Preparation
- To charge the remote control, connect the charger's plug to the charging port and the charger to an outlet
- The transmitter's red light will turn on, and you should charge the transmitter for no more than 3.5 hours at a time
- After a full charge, the red LED light will turn off automatically
- When the Q symbol appears in the lower right corner of the LCD screen, it means the battery is low
Transmitter Preparation
- To turn the transmitter on or off, press the power button for 5 seconds
- Press the power button to switch to different levels (the indicators on the screen will change)
- Press the up and down buttons on the right side to adjust the level
- If the transmitter remains idle for 20 seconds, it will enter standby mode, and if it does not operate for 2 minutes, it will turn off
- If the transmitter enters standby mode, press any button (except the LED light button) to operate
Collar Preparation
- To charge the collar, plug the charger plug into the charging port and connect the charger to an outlet
- The red LED light inside the collar-receiver will turn on. You should charge the collar-receiver for 3.5 hours each time. After a full charge, the red LED light will turn off automatically
- When charging is complete, place the rubber cover in the correct position to keep the internal unit away from dust and water
- When the collar starts beeping every 2 minutes, it means it has a low battery
Transmitter Connection with the Receiver-Collar
- Turn on the transmitter and select 1 or 2 channels for coding.
- Lift the rubber cover part on the collar-receiver
- Use a toothpick or click on the paper to insert into the reset hole inside the collar receiver
- Press the START button on the transmitter and immediately, you will hear a beep from the collar
- The collar-receiver will beep. This means that the transmitter has been tuned with the collar
- After completion, put the rubber cover in the correct position to keep the internal unit away from dust and water
The Package Includes
- 1 rechargeable remote control
- 1 rechargeable collar
- 1 charger with power cable
- 1 test light
- Operating instructions
- Usage
- Education
- Operation
- with Vibration, Sound & Ultrasound
- for Cat
- No
- Range
- 300 m
- Power Supply
- Rechargeable
- with Subscription
- No
Important information
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.